IEEE Seismic Restraint Kit 2x Bracket & Clips 45Deg 5m Red

The optimum angle for installation of a seismic brace is 45°. Most international seismic design standards advise using an ultimate limit-state (ULS) design method for earthquake loads. In case the cables of a
bracing system (two-way or four-way) are installed with different angles, the capacity of the system is evaluated based on the largest angle, i.e. the lesser angular capacity

Installing cable braces with an angle larger than 60° from horizontal is not recommended by Zip-Clip since it adversely impacts the performance of cables in tension.

Note: Packaged in multiples of two (2).